1,037
edits
Changes
Jump to navigation
Jump to search
Line 164:
Line 164: − + +
Hot Water Fiber Bending Procedure (view source)
Revision as of 19:00, 29 May 2014
, 19:00, 29 May 2014→Use the Start Buttons
***If either heater gets more than five degrees hotter than the water turn off the heaters but not the pumps.
***If either heater gets more than five degrees hotter than the water turn off the heaters but not the pumps.
***After 10 minutes turn off the pumps then siphon both the lines using the procedure above then restart the LabView program.
***After 10 minutes turn off the pumps then siphon both the lines using the procedure above then restart the LabView program.
*The temperature should reach 160-162 degrees Fahrenheit before bending starts.
*The temperature reading from the thermistor, displayed in "Temperature Degrees Fahrenheit," should reach 155 degrees before bending starts.
**The actual temperature is about 4 degrees higher according to the alcohol thermometer.
===Bending===
===Bending===