1,037
edits
Changes
Jump to navigation
Jump to search
Line 156:
Line 156: − + − + + + +
Hot Water Fiber Bending Procedure (view source)
Revision as of 15:05, 29 May 2014
, 15:05, 29 May 2014→Let the Program Do It
*In the Edit menu, reinitialize values to default. Don't do this if you have already done the next step.
*In the Edit menu, reinitialize values to default. Don't do this if you have already done the next step.
*Using the hand tool from the tools menu, set a time of day in the "Completion Time" control for when the water should reach its maximum temperature. Don't bother setting a date. It doesn't matter.
*Using the hand tool from the tools menu, set a time of day in the "Completion Time" control for when the water should reach its maximum temperature. Don't bother setting a date. It doesn't matter.
*The target time must be less than 24 hours away.
*The Completion Time is in 24-hour format. If it is 1:00 PM, you will need to put 13:00:00.000.
*Click on the dials for "Heater and Pump 1" and "Heater and Pump 2" to turn on all water heaters and pump.
*The target time must be less than 24 hours away.
*Run the program. It will calculate how long it needs to heat the water and start the heaters and pumps when necessary.
====Use the Start Buttons====
*Click on the dials for "Start Heater and Pump 1" and "Start Heater and Pump 2" to turn on all water heaters and pump.
**There are three temperatures listed on the interface. There is the water temperature, and the two surface temperatures of each heater. Watch for about ten (10) minutes to make sure neither heater gets more than 3-5 degrees Fahrenheit hotter than the water temperature.
**There are three temperatures listed on the interface. There is the water temperature, and the two surface temperatures of each heater. Watch for about ten (10) minutes to make sure neither heater gets more than 3-5 degrees Fahrenheit hotter than the water temperature.
***If either heater gets more than five degrees hotter than the water turn off the heaters but not the pumps.
***If either heater gets more than five degrees hotter than the water turn off the heaters but not the pumps.