639
edits
Changes
Jump to navigation
Jump to search
mLine 10:
Line 10: + + + + + + + + + +
Fiber Rough Cut Procedure (view source)
Revision as of 16:19, 8 January 2014
, 16:19, 8 January 2014no edit summary
* Make sure the Dremel cutting tool is unplugged then visually inspect:
* Make sure the Dremel cutting tool is unplugged then visually inspect:
** Ensure cutting wheel is secure and not cracked
** Ensure cutting wheel is secure and not cracked
** Verify electrical cord is in good working order.
** Make sure the power switch is in the off position.
* Plug in the Dremel tool.
* Set the cutting speed to 7.
*Check that the ventilation hose is secure and start the ventilation system.
*Flip up the opening to the spool storage box to expose the two slots with the protruding optical fibers.
*Select a fiber spool to cut from and remove the clip holding the corresponding fiber in place.
** Ensure the fiber is held securely prior to release of the clip
** If the fiber falls into the storage box:
*** Remove the side panel on the spool storage box using a razor knife to cut the tape.