Changes

==Rail System==

==Rail System==

*very costly

*very costly

*possibly too heavy duty for this application

*possibly too heavy duty for this application

*Stepper motor with micro controller stands stationary on one end and calibration device would be connected to a slide rail system for stability[[File:Gears 01.gif|thumb|Clamping Plate Setup http://www.polytechdesign.com/images/gears_01.gif]]

*Stepper motor with micro controller stands stationary on one end and calibration device would be connected to a slide rail system for stability[[File:Gears 01.gif|thumb|Clamping Plate Setup http://www.polytechdesign.com/images/gears_01.gif]]

*We need to find something that is low cost but is accurate enough to be stopped at each fiber array block. This would call for a low pitch. One example I've found is as low as 8mm pitch with 200 teeth making a 1.6 meter timing belt. Because the intended light source for calibration is most likely going to have a wide range, 8mm is a fair sized step as the scintillators are 2mm each but grouped in blocks.

*We need to find something that is low cost but is accurate enough to be stopped at each fiber array block. This would call for a low pitch. One example I've found is as low as 8mm pitch with 200 teeth making a 1.6 meter timing belt. Because the intended light source for calibration is most likely going to have a wide range, 8mm is a fair sized step as the scintillators are 2mm each but grouped in blocks.

==== Motor ====

==== Motor ====

*Need to locate a stepper motor to attach to one end of the pulley belt system

*Need to locate a stepper motor to attach to one end of the pulley belt system