179
edits
Changes
Jump to navigation
Jump to search
Line 18:
Line 18: − +
Temperature Control Program (view source)
Revision as of 21:16, 17 December 2015
, 21:16, 17 December 2015→Instructions for a Heating Run
*Start Timer: On to start timer when the program starts, off otherwise. *Can turn this on at any point during run.<br/>
*Start Timer: On to start timer when the program starts, off otherwise. *Can turn this on at any point during run.<br/>
Once all of these are set appropriately the run can begin. Pressing the LabView Run button on the tool bar will initiate all relevant processes and the hotplate should turn on within the first twenty seconds assuming the interior box temperature is less than 175 degrees Fahrenheit. When the netbooter is on and supplying voltage to the hotplate an indicator light on the front of the netbooter under "Power Outlet Status 1" will be on. If the program needs to be stopped in the middle of a run, the "STOP" button must be pressed; as a general rule do not end the program with the Abort Execution Labview button in the tool bar while the netbooter indicator light for outlet one is still on. If this does happen by accident, the program can be started again and the "STOP" button pressed while it is running.
Once all of these are set appropriately the run can begin. Pressing the LabView Run button on the tool bar will initiate all relevant processes and the hotplate will turn on within the first twenty seconds assuming the interior box temperature is less than 175 degrees Fahrenheit. When the netbooter is on and supplying voltage to the hotplate an indicator light on the front of the netbooter under "Power Outlet Status 1" will be on. If the program needs to be stopped in the middle of a run, the "STOP" button must be pressed; as a general rule do not end the program with the Abort Execution Labview button in the tool bar while the netbooter indicator light for outlet one is still on. If this does happen by accident, the program can be started again and the "STOP" button pressed while it is running.
In order to calibrate the communication between the DAQ and the computer, the program InstaCal must be used
In order to calibrate the communication between the DAQ and the computer, the program InstaCal must be used