289
edits
Changes
Jump to navigation
Jump to search
Line 14:
Line 14: + +
Hot Water Fiber Bending Procedure (view source)
Revision as of 14:38, 20 May 2014
, 14:38, 20 May 2014→Orientation
*Be sure that the chimneys and the bottom halves of the collars are attached to their appropriate plates.
*Be sure that the chimneys and the bottom halves of the collars are attached to their appropriate plates.
*Turn off all overhead lights and turn on the UV protected lights over the bending unit.
*Open the intermediate storage box and remove the fibers you will be bending. Place these fibers on a flat surface, always being cautious with the fuse site.
*Open the intermediate storage box and remove the fibers you will be bending. Place these fibers on a flat surface, always being cautious with the fuse site.