639
edits
Changes
Jump to navigation
Jump to search
Line 13:
Line 13: + + +
Fiber Painting Procedure (view source)
Revision as of 21:25, 15 January 2014
, 21:25, 15 January 2014no edit summary
* Pour the paint in to the airbrush reservoir until it is about 3/4 full.
* Pour the paint in to the airbrush reservoir until it is about 3/4 full.
** The lid should seal any unused paint in the plastic container. When the airbrush runs out of paint, it can be replenished from this source.
** The lid should seal any unused paint in the plastic container. When the airbrush runs out of paint, it can be replenished from this source.
* Use the airbrush painter to apply a thin, even coat of paint to the fiber.
* Start at the scintillating end of the fiber
** To avoid painting the face of the scintillating fiber, butt it up against a flat surface and apply paint to the sides. Be careful not to lift the fiber from the flat surface until all of the painting is done on the scintillating fiber.