Changes

| [[File:splicing fuse lip.JPG|thumb|upright|Check the fuse site for small imperfections like this.]]

| [[File:splicing fuse lip.JPG|thumb|upright|Check the fuse site for small imperfections like this.]]

| [[File:splicing fuse lip sanding.JPG|thumb|upright|If a lip has formed, sand it off, careful to only sand at at the corner to prevent damage to the optical cladding.]]

| [[File:splicing fuse lip sanding.JPG|thumb|upright|If a lip has formed, sand it off, careful to only sand at at the corner to prevent damage to the optical cladding.]]

| [[File:splicing fiber finished.JPG|thumb|upright|A finished fuse between two pieces of lightguide fiber, for example.]]

| [[File:|thumb|upright|A finished fuse between two pieces of lightguide fiber, for example.]]

|}

|}

* When a bundle is completed, turn off the fusing unit by turning the two power switches off. Underneath the fusing unit, decrease the pressure of the compressor and turn off the red switch which powers the compressor.

* When a bundle is completed, turn off the fusing unit by turning the two power switches off. Underneath the fusing unit, decrease the pressure of the compressor and turn off the red switch which powers the compressor.