289
edits
Changes
Jump to navigation
Jump to search
Line 13:
Line 13: − During the summer of 2012, Ben Willis wrote a LabView program that would communicate with a NetBooter and ultimately control a heater and water pump. LabView also plots the temperature of water being heated, and plots the changing temperatures on a graph on the front panel. Before Ben left, he wrote a [[media:Final_Report.pdf|final report]] of his work on the program and in the lab in general. I have added a little to Ben's work, mostly housekeeping; deleting some non functioning commands, adding the equation to represent temperature based on voltage, adding an equation for a thermocouple, and connecting with the DAQ. I also plan to make a differential op-amp to allow the DAQ to read the inputs given by the thermocouple. In this way, we will be able to use a thermistor and two thermocouples to control the water temperature in both the straightening pipe and the bending tank.+ − − − I had found a lab manual from the University of Minnesota that gave step by step instructions for taking and recording temperature measurements using a thermistor, a DAQ, and LabView. After making the circuit and updating the LabView program it seems to be working within expected error. − − [[media:LabViewThermistor.pdf|The Lab Manual]] − − − − <gallery> − File:LabViewProgram3.PNG|The front panel of the LabView program. − File:LabViewProgram1.PNG|Part 1 of the block diagram: The majority of this part of the program is to read the output given by the DAQ, translate it to a temperature, and plot the results. − File:LabViewProgram2.PNG|Part 2 of the block diagram: The main purpose of this part of the program is to determine if the temperature read from part 1 is what was specified in the front panel, and to turn the water pump and heater on or off as appropriate. − </gallery> − − <gallery> − File:LabViewToCompare.PNG|A view of the LabView front panel that Ben and I created. The voltage and temperature are actual readings/calculations that have been made. − File:LabToCompare.PNG|A view of the lab that inspired the thermistor idea. The numbers are a close comparison of the measured data in the previous picture. − </gallery> +
Construction of the Full-Scale Tagger Microscope (view source)
Revision as of 17:55, 23 July 2013
, 17:55, 23 July 2013→LabView Program
==LabView Program==
==LabView Program==
This page details the work that has gone into the LabView program that was written to control the heaters and pumps for the bending tank in 405.
[[LabView Program Explanation]]
==Temperature Measurements==
==Temperature Measurements==