Changes

While Igor was finalizing his amplifier/summing circuit, I worked briefly on design of the backplane. A number of details regarding trace impedance and board dimensions were ironed out. Nonetheless, many problems still remain which I will need to tackle over the summer. The first of these problems is that we have yet to find an appropriate low cost coaxial connector to route signals off the backplane. In addition, screws with which to mount the backplane to the tagger must be selected so that appropriate holes can be created for them on the PCB.

While Igor was finalizing his amplifier/summing circuit, I worked briefly on design of the backplane. A number of details regarding trace impedance and board dimensions were ironed out. Nonetheless, many problems still remain which I will need to tackle over the summer. The first of these problems is that we have yet to find an appropriate low cost coaxial connector to route signals off the backplane. In addition, screws with which to mount the backplane to the tagger must be selected so that appropriate holes can be created for them on the PCB.

Once we were satisfied that the amplifier/summing circuit performed as required, I shifted work from the backplane to the amplifier board. Around the same time, I began working on a poster to present my work at the Frontiers in Undergraduate Research Exhibition held during Open House Weekend here at UConn. If you’re interested in my poster, check it out here.14:49, 5 May 2009 (EDT)14:49, 5 May 2009 (EDT)[[User:Underwood|Underwood]]

Once we were satisfied that the amplifier/summing circuit performed as required, I shifted work from the backplane to the amplifier board. Around the same time, I began working on a poster to present my work at the Frontiers in Undergraduate Research Exhibition held during Open House Weekend here at UConn. If you’re interested in my poster, check it out here.

To start the amplifier/summing circuit project, I searched high and low for information about how to handle multi-channel designs in Altium. Not surprisingly, the first Google result on the query “multichannel design Altium” had everything I was missing during the fall when I was trying to lay out the original amplifier circuit. Using my new knowledge of Altium’s multichannel capabilities, I captured Igor’s new design into the schematics editor of Altium Designer. With proper nested schematic sheets, the entire 30 channel amplifier/6 channel summer design was compressed into just 4 schematic sheets, vs. the ~40 or so that would have been required had I laid out the complete schematics of the old design.  

To start the amplifier/summing circuit project, I searched high and low for information about how to handle multi-channel designs in Altium. Not surprisingly, the first Google result on the query “multichannel design Altium” had everything I was missing during the fall when I was trying to lay out the original amplifier circuit. Using my new knowledge of Altium’s multichannel capabilities, I captured Igor’s new design into the schematics editor of Altium Designer. With proper nested schematic sheets, the entire 30 channel amplifier/6 channel summer design was compressed into just 4 schematic sheets, vs. the ~40 or so that would have been required had I laid out the complete schematics of the old design.