1,004
edits
Changes
Jump to navigation
Jump to search
mLine 59:
Line 59: + + + + + + + + + + + + + + + + + + + +
Hardware for Mounting of Diamond Radiators (view source)
Revision as of 13:51, 28 April 2009
, 13:51, 28 April 2009no edit summary
[[Image:Dia_Yboundary.jpg|thumb|330px|Figure 7. A strange artifact, potentially challenging the notion that this is a mono-crystal. A slightly different lighting angle shows very flat surfaces (so these are not likely surface features.)]]
[[Image:Dia_Yboundary.jpg|thumb|330px|Figure 7. A strange artifact, potentially challenging the notion that this is a mono-crystal. A slightly different lighting angle shows very flat surfaces (so these are not likely surface features.)]]
=== Minimal Supply List for Diamond Mounting ===
The following is a useful minimal tool kit for mounting the diamonds on wires clamped in the holder described above.
* Supertacker 351
* toluene
* alcohol
* kim wipes
* cotton swab tips
* clear plastic wrap
* foil
* Scotch tape
* scissors
* hex driver for size 4 cap screw
* tweezers (point tip preferred)
* (2) 10-32 screws
* ~5g weight with wire clamp (thumb screw, mating threaded stand-off, 2 washers)
* twist ties
* ''recommended'': vice, 2" mouth minimum