1,037
edits
Changes
Jump to navigation
Jump to search
Line 53:
Line 53: − + + +
no edit summary
2/23: I tried to run a fiber test, but the charts came up blank.
2/23: I tried to run a fiber test, but the charts came up blank.
I continued polishing the sci-fis. I have some problems with measuring with the feeler gauges. It seems that while polishing there is less space for a feeler gauge than when the wheel is at rest. For example, with the 0.25" feeler gauge in place, the fibers don't touch the paper as the wheel is spinning.
I continued polishing the sci-fis. I have some problems with measuring with the feeler gauges. It seems that while polishing there is less space for a feeler gauge than when the wheel is at rest. For example, with the 0.025" feeler gauge in place, the fibers don't touch the paper as the wheel is spinning. It's the same with the 0.024" gauge, but with 0.022" and 0.020", there is a little contact.
I was about to contrast this with the wheel at rest, but now I'm not so sure. I just found that at rest the 0.025" and 0.024" feeler gauges didn't fall down as I had seen earlier, but I had to press hard to keep them up. I will have to think some more about this