105
edits
Changes
Jump to navigation
Jump to search
mLine 12:
Line 12: − ** Ensure cutting wheel is secure and not cracked − +
Fiber Rough Cut Procedure (view source)
Revision as of 13:39, 5 January 2018
, 13:39, 5 January 2018no edit summary
* Locate logbook used for data recording.
* Locate logbook used for data recording.
* Make sure the Dremel cutting tool is unplugged then visually inspect:
* Make sure the Dremel cutting tool is unplugged then visually inspect:
** Verify electrical cord is in good working order.
** Verify electrical cord is in good working order.
** Make sure the power switch is in the off position.
** Make sure the power switch is in the off position.
* Put a diamond blade on the Dremel.
* Put a diamond blade on the Dremel. (Ensure that the cutting wheel is secure and not cracked.)
[[File:Dremel2.JPG|thumb|center|upright|The Dremel tool used to cut the fibers, with a diamond blade and foam pad, and an example of appropriate eye wear.]]
[[File:Dremel2.JPG|thumb|center|upright|The Dremel tool used to cut the fibers, with a diamond blade and foam pad, and an example of appropriate eye wear.]]