Line 25: |
Line 25: |
| | | |
| =Calibration Graphs for Four Thermistors= | | =Calibration Graphs for Four Thermistors= |
| + | |
| + | The adjusted variables for the thermistor temperature formula are shown below each calibration graph. |
| | | |
| ==Back Center== | | ==Back Center== |
Line 54: |
Line 56: |
| [[File:BWBottomCenterVars8112015.png]] | | [[File:BWBottomCenterVars8112015.png]] |
| | | |
| + | =All Temperature Data from Calibration Tests= |
| | | |
| + | These graphs display temperature data from all thermistors during the calibration runs. |
| | | |
| [[File:BWBackCenterAll8182015.png]] | | [[File:BWBackCenterAll8182015.png]] |
Line 69: |
Line 73: |
| | | |
| [[File:BWBottomCenterAll8182015.png]] | | [[File:BWBottomCenterAll8182015.png]] |
| + | |
| + | =Other Tests= |
| + | |
| + | [[File:BWThermistors7162015.png]] |
| + | |
| + | |
| + | |
| + | [[File:BWThermistors7202015.png]] |
| + | |
| + | |
| + | |
| + | [[File:BWFansOnLate7272015.png]] |
| + | |
| + | The test thermistor was at the front left end. |
| | | |
| | | |
− | ==Other Tests==
| + | [[File:BWThermistors7272015.png]] |
| + | |
| + | The test thermistor was at the middle right end. This run began immediately after the previous run ended, and the box did not completely cool. |
| + | |
| | | |
| [[File:BW8112015BackCenter.png]] | | [[File:BW8112015BackCenter.png]] |
Line 91: |
Line 112: |
| [[File:BW8182015TwoDays.png]] | | [[File:BW8182015TwoDays.png]] |
| | | |
| + | |
| + | |
| + | [[File:BWBriefTest1-8242015.png]] |
| | | |
| =Next Steps= | | =Next Steps= |
Line 96: |
Line 120: |
| The current LabVIEW program sometimes records a zero or #NV in the temperature data file. We should change the program to so that it replaces a zero or NaN with the previous temperature. If a second zero or NaN occurs immediately after the first, LabVIEW should not replace the second one with another value. | | The current LabVIEW program sometimes records a zero or #NV in the temperature data file. We should change the program to so that it replaces a zero or NaN with the previous temperature. If a second zero or NaN occurs immediately after the first, LabVIEW should not replace the second one with another value. |
| | | |
− | [[LabVIEW Resources]] | + | [https://drive.google.com/open?id=0B4wCyytpeOAgfk5UQnZzSkFIUUVRQXIyNmVKYWhJR3hRa2l6bi1yZjhEQzhKVTJpZzcxM3M LabVIEW Resources] |