SiPM digital control board power supplies

From UConn PAN
Revision as of 14:13, 26 June 2008 by Underwood (talk | contribs) (→‎ICs requiring +5V: fixed note that was in description instead)
Jump to navigation Jump to search

As seen in the SiPM digital control board netlist, the ICs on the control board have many different power requirements. In total there are 6 different voltages required. To minimize the number of actual power supplies needed, however, we plan on supplying only +5V, -5V, and +210V to the board from external power supplies. The other voltages will be created by appropriate voltage regulator ICs on the control board.

+5V supply

The +5V supply is responsible for powering most of the components on the control board. Here is a breakdown of those components by their voltage requirements. Voltages less than +5V will be created using voltage regulators

ICs requiring +5V

IC Name Pin Name Tolerance Current Requirements Description Notes
AD5535 V+ ±0.25V 0.5mA typ, 1mA max Positive amplifier
AD5535 AVCC ±0.25V 15mA typ, 18mA max Analog supply
AD7928 AVDD ±0.25V 2.7mA max operating Analog supply AVDD can be as low as 2.7V if voltages measured never exceed 2.5V

ICs requiring +3.3V

IC Name Pin Name Tolerance Current Requirements Description Notes
AD5535 ANODE large set by external resistor Temperature sensing diode Diode drop varies w/ temperature. Requires external current limiting resistor.
AD5535 REF_IN ~±0.4V 1.25uA max Reference voltage Should be as high as possible but not exceed AVCC-1.15V
AD7314 VDD ±0.3V 1.2mA typ operating Indicates ±1°C precision
AD7928 VDRIVE ±0.3V 200uA Logic output driver
CP2201 AV+ ±0.3V ??? Analog supply pin
CP2201 VDD1 ±0.3V 75mA typ, 155mA max operating Digital supply pin
CP2201 VDD2 ±0.3V 75mA typ, 155mA max operating Digital supply pin
XC3S50A VCCAUX ±0.3V Varies Auxiliary power supply FPGA program greatly affects power requirements
XC3S50A VCCO ±0.3V Varies Auxiliary power supply FPGA program greatly affects power requirements

ICs requiring 2.5V

IC Name Pin Name Tolerance Current Requirements Description Notes
AD7928 REF_IN ±1% (±0.025V) ±1uA max Reference voltage

| ANODE | large | set by external resistor | Temperature sensing diode | Diode drop varies w/ temperature. Requires external current limiting resistor.


-5V supply

Use for:

  • AD5535 DAC
    • V- amplifier supply pins

+210V supply

Use for:

  • AD5535 DAC
    • VPP high voltage supply
      • Using this high voltage will allow for large adjustments of the SiPM amplifier bias voltages. Large variations may be necessary because the MATLAB model showed that adjustments between 0 and +50V had no effect on the SiPM.