1,870
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + Line 67:
Line 68: − + Line 90:
Line 91: + + + + +
Hardware for Mounting of Diamond Radiators (view source)
Revision as of 17:24, 27 August 2011
, 17:24, 27 August 2011→References
== Mounting Bracket ==
== Mounting Bracket ==
The following hardware was built in preparation for the May, 2009 CHESS run.
[[Image:DiaMountBracket.png|frame|Exploded view of the mounting bracket with the diamond shown suspended on stretched wires.]]
[[Image:DiaMountBracket.png|frame|Exploded view of the mounting bracket with the diamond shown suspended on stretched wires.]]
| [[Image:DiaGlued.jpg|thumb|250px|Figure 6. The photo shows the diamond glued to 20 μm wires spaced by the minor diameter of 10-32 screws.]]
| [[Image:DiaGlued.jpg|thumb|250px|Figure 6. The photo shows the diamond glued to 20 μm wires spaced by the minor diameter of 10-32 screws.]]
||
||
| [[Image:Dia_Yboundary.jpg|thumb|220px|Figure 7. A strange artifact, potentially challenging the notion that this is a mono-crystal. A slightly different lighting angle shows very flat surfaces (so these are not likely surface features.)]]
| [[Image:Dia_Yboundary.jpg|thumb|220px|Figure 7. A strange artifact, potentially challenging the notion that this is a mono-crystal. A slightly different lighting angle shows very flat surfaces (so these are not likely surface features.) Photo orientation: left is the direction of the goniometer mounting rod.]]
|}
|}
* twist ties
* twist ties
* ''recommended'': vice, 2" mouth minimum
* ''recommended'': vice, 2" mouth minimum
== References ==
* [http://www.xhuber.de/en/Products/diffractometers/xray/single_crystal/5020/5020.rsys Diffractometer at CHESS]
* [http://zeus.phys.uconn.edu/~senderovich/GlueX/Diamonds/MountingBracket/DiaMountBracket_Shaft.pdf Diamond mount support post]