10
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + + + + + + + + + + + + + + + + + + +
AMCImportant procedure to follow when filling the tank (view source)
Revision as of 20:08, 21 November 2013
, 20:08, 21 November 2013no edit summary
When filling the bending tank and/or the straightening pvc pipe it is crucial that all air is out of the piping system before the heaters and pumps are left on without direct supervision. It was found that adding any substantial amount of tap water to the redesigned system, to fill either the tank or the pipe, allows small air bubbles to collect in the pipes. The small air bubbles, at first, are not an issue as they do not impede water flow through the system. After a number of minutes, however, the air bubbles coalesce into fewer big bubbles that do block the flow of water. Because of this, the tank should be emptied only when necessary. If it is crucial to empty the tank, then this procedure (and great diligence) should be followed when filling it again. <span style="color:red">If this procedure is not followed, chances are good that you will break one or more pieces of equipment!</span>
When filling the bending tank and/or the straightening pvc pipe it is crucial that all air is out of the piping system before the heaters and pumps are left on without direct supervision. It was found that adding any substantial amount of tap water to the redesigned system, to fill either the tank or the pipe, allows small air bubbles to collect in the pipes. The small air bubbles, at first, are not an issue as they do not impede water flow through the system. After a number of minutes, however, the air bubbles coalesce into fewer big bubbles that do block the flow of water. Because of this, the tank should be emptied only when necessary. If it is crucial to empty the tank, then this procedure (and great diligence) should be followed when filling it again. <span style="color:red">If this procedure is not followed, chances are good that you will break one or more pieces of equipment!</span>
<span style="color:Black">Changes have been made to the process by which the pvc pipe is filled. The new procedure is in Green. The old procedure is to be considered as secondary</span>
<span style="color:green">To fill PVC:
<span style="color:green">valves 1,3,6 are open
<span style="color:green">valves 2,4,5 are closed
<span style="color:green">Fill until water comes out
<span style="color:green">Open everything to bleed out air
<span style="color:green">close valves 5,6,4,1, leaving only vales 3 and 2 open.
<span style="color:green">run program
</span>
1. Make sure the valves are in the correct positions to either fill the tank or the pipe. Refer to [[Water Tank Instructions and Diagrams | this page]] for the proper procedure.
1. Make sure the valves are in the correct positions to either fill the tank or the pipe. Refer to [[Water Tank Instructions and Diagrams | this page]] for the proper procedure.