1,004
edits
Changes
Jump to navigation
Jump to search
m
no edit summary
Line 1:
Line 1:
=== ADC/Temperature Sensor Integration ===
−The ADC ([http://www.analog.com/en/prod/0%2C2877%2CAD7928%2C00.html AD7928]) and Temperature Sensor ([http://www.analog.com/en/prod/0%2C2877%2CAD7314%2C00.html AD7314]) communicate over very similar, SPI-like interfaces. It was therefore decided that the controllers for these chips should be merges into a single module in the FPGA. The combined module serves to abstract the details of the communication protocol with these sensors.+-----------------+
+This module aims to merge the ADC and temperature sensor modules into a single module. Both modules communicate over a shared SPI-like bus, and there are many structural and functional similarities between the two. However, this is a partially completed project. The current VHDL files (which are mostly written but need to be tested) can be found at:+* [http://zeus.phys.uconn.edu/halld/tagger/electronics/design-6-2007/SPI_VHDL.zip SPI Module].
−The subprojects (i.e. earlier versions of the separate ADC and temperature sensor modules) can be found at:
−* [http://zeus.phys.uconn.edu/halld/tagger/electronics/design-6-2007/ADC_VHDL.zip ADC Module]
−* [http://zeus.phys.uconn.edu/halld/tagger/electronics/design-6-2007/Temp_VHDL.zip Temperature Sensor Module]
'''This page discusses a project currently under development. Please be aware that information on this page may change as the project progresses.'''
'''This page discusses a project currently under development. Please be aware that information on this page may change as the project progresses.'''
+The ADC ([http://www.analog.com/en/prod/0%2C2877%2CAD7928%2C00.html AD7928]) and Temperature Sensor ([http://www.analog.com/en/prod/0%2C2877%2CAD7314%2C00.html AD7314]) communicate over very similar, SPI-like interfaces. It was therefore decided that the controllers for these chips should be merges into a single module in the FPGA. The combined module serves to abstract the details of the communication protocol with these sensors.
−== SPI Module Interface ==
* inputs
* inputs
Line 26:
Line 26:
−== SPI Module Components ==
+The components of this module follow directly from its predecessors (see [[Programming the temperature sensor]] and [[Programming the ADC]]). Two important components were added, however, to further abstract ADC communication protocol via "Process Control" (A_proccontrol) unit and to properly supervise the chip's reset cycle (ADCreset).
−The ADC requires two dummy conversations upon reset or startup. The ADCreset unit forces these two cycles to take place. A request for data on a new ADC line (compared to last request) requires one write cycle to the ADC control buffer and then the ordinary read cycle. A_proccontrol determines whether to perform a write cycle. The "Done" pulse is withheld if the competed cycle is a control buffer write cycle or reset cycles mentioned above. Only the final read cycle merits the external "Done" pulse.
−