SiPM Amplifier

The silicon photomultipliers (SiPM) we are using in our experiment were purchased from Photonique. Photonique also supplies analog electronics boards to amplify the signals from the SiPMs. This page discusses the analysis and modeling of the amplifier circuit.

The circuit diagram

Component values

Part	On-chip label	Actual component
Resistors
$R_{1}$	104	$100k\Omega$
$R_{2}$	103	$10k\Omega$
$R_{3}$	562	$5.6k\Omega$
$R_{4}$	202	$2k\Omega$
$R_{5}$	102	$1k\Omega$
$R_{6}$	510	$51\Omega$
$R_{7}$	241	$240\Omega$
Transistors
$VT_{1}$	E2P (1717)	Philips BFS 17A
$VT_{2}$	W1S (13)	Philips BFT 92

The amplifier circuit diagram shown here was developed through combining the diagram supplied by Photonique (lacking component values, and having several extra components) and the physical circuit (having most components labeled).

The component values are shown to the right. The capacitors are unlabeled on any diagram, so values are not known for those components.

MATLAB model

We developed a model for this circuit in MATLAB to simulate its behavior and study various parameters, especially gain as a function of power voltage. The Photonique documentation claims that the power voltage can be varied between four and nine volts in order to tune the gain of the amplifier.