Microscope Prototype Mechanical Design Drawings
Revision as of 19:53, 20 December 2010 by Mcintyre (talk | contribs) (→TAGGER MICROSCOPE PROTOTYPE)
TAGGER MICROSCOPE PROTOTYPE
![]() |
Purpose
The purpose of this page is to list the pertinent files used during the design and construction of the Prototype for the Tagger Microscope.
Repository
Mechanical Drawings
- Top Plate - Top View of Back-Plane, Amp. Board, & Card Guides (TurboCad v12 / AutoCad 2010)
- Top Plate – Holes & Cut-out (TurboCad v12 / AutoCad 2010)
- Top Plate – Holes to be drilled (TurboCad v12 / AutoCad 2010)
- Top Plate – Cut-Out only (TurboCad v12 / AutoCad 2010)
- Bottom Guard for Amplifier Board (TurboCad v12 / AutoCad 2010)
- Backplane Board (TurboCad v12 / AutoCad 2010)
- Amplifier Board (TurboCad v12 / AutoCad 2010)
- Digital Board (TurboCad v12 / AutoCad 2010)
- Bottom Plate (TurboCad v12 / AutoCad 2010)
- 4x4 mm Pack (TurboCad v12 / AutoCad 2010)
- Prototype Feet (TurboCad v12 / AutoCad 2010)
Data Sheets
- Sponge Gasket Data Sheet (PDF)
- Hardware Parts List (Excel)
- Pin-out of Euro Connector Receptacle-48pin (PDF)
- Pin-out of Euro Connector Receptacle-96pin (PDF)
- Pin-out of Euro Connector Right Angle Receptacle-96pin (PDF)
- Mechanical Data Sheets (Folder)
- Scintillating Optical Fibers Brochure (PDF)
- Scintillation Materials and Assemblies Brochure (PDF)
Pictures
- Pictures of the Amplifier Board Close-up (Folder)
- Pictures of the Prototype Set-up Prior to Welding (Folder)
- Pictures Non-Welded Frame (Folder)
- Pictures of the Glued Spacer on the Amp Board (Folder)
- Pictures of the Hall-B Beamline (Folder)
- Lowes Trip for Heat Treating Unit (Folder)