BW April 2018
4/2: I sanded several thick fibers in bundle 405 to get them through the chimneys more easily. Andrew put the fibers back in the collar and aligned them before I left, but we still wanted to improve the alignment. I recorded the new configuration and tried to improve the alignment, but a Kapton strip broke and after I replaced it I did not get a very good alignment.
I also practiced fusing today.
4/4: This week I started polishing a fourth bundle of sci-fis. I am still twisting right in front and left in back. The wheel is running in reverse.
Yesterday during fusing practice the hook on one of the 500 g weights broke, and today Jim suggested wire as a replacement.
I worked on preparing light guide bundle 403 for testing today.
4/5: After several attempts by Andrew and me, I put bundle 403 in the dark box with a satisfactory alignment. I started running tests.
I changed the 400 grit sandpaper, and polishing went much faster. Bundle 4 is now less than 0.005" from the target length of 0.787". However, it is hard for me to tell where we bottom out - i.e., which is the smallest feeler gauge that prevents the bundle from touching the sandpaper. There seems to be a gradation of contact between the fibers and the grit, with a thick feeler gauge such as 0.025" allowing slight brushing contact while 0.015" allows the paper to scrape vigorously against the fibers.
4/6: Dr. Jones said it would be good for me to start fusing soon. We won't throw away fibers if fusing goes wrong. We'll just cut them and polish them again.
When the fibers are all tested, I need to come up with charts showing bell curves of all the test results. There should be one peak. However, I would expect two because of the difference between offset fibers.
I asked about telling which end of a sci-fi is highly polished, and Dr. Jones suggested using a microscope. I responded that it would probably be faster to polish both ends of the fibers. He said that would be all right if it doesn't take too long.
4/10: We may need some more fine-grit sandpaper. Ideally I want each sheet to suffice for four sci-fi bundle ends, which means two bundles if we polish both ends of the bundles and four bundles if we polish only one end of the bundles. However, it might sometimes take more than one circular piece to polish one bundle end, so it's more likely that I will need more sandpaper than less. I may need more 5 micron grit too to sand fibers for the chimneys.