179
edits
Changes
Jump to navigation
Jump to search
Line 5:
Line 5: − +
Temperature Control Program (view source)
Revision as of 18:33, 9 December 2015
, 18:33, 9 December 2015no edit summary
==Instructions for a Heating Run==
==Instructions for a Heating Run==
Before setting the program to run as desired, the physical setup must first be appropriately configured. The hotplate should be plugged into outlet one on the correct netbooter (usually the top netbooter)
Before setting the program to run as desired, the physical setup must first be appropriately configured. To set the hotplate temperature, plug it into a regular wall outlet and turn the knob until the temperature display reads 140 degrees Celsius, then unplug it. Next, plug the hotplate into outlet one on the correct netbooter (usually the top netbooter) as the state of this outlet will be controlled by the program. Finally, plug all fans in and look to see that they are actually spinning.<br/><br/>
In order to perform a heating run there are a number of parameters, which can be found of the front panel that must be set properly. The conditions for a normal run are listed below:
In order to perform a heating run there are a number of parameters, which can be found of the front panel that must be set properly. The conditions for a normal run are listed below: