Changes

2/16: Yesterday I started polishing a bundle of sci-fis that are cut to 0.907 inches. The screw holding the collar on the guide was on the left. With the micrometer I measured the space where we put the feeler gauges. It was about 0.09". I wanted to try bottoming out to the 0.025" feeler gauge. I twisted right in front at the polishing wheel and left in back away from the wheel.

2/16: Yesterday I started polishing a bundle of sci-fis that are cut to 0.907 inches. The screw holding the collar on the guide was on the left. With the micrometer I measured the space where we put the feeler gauges. It was about 0.09". I wanted to try bottoming out to the 0.025" feeler gauge. I twisted right in front at the polishing wheel and left in back away from the wheel.

2/19: Using the Carson camera, I identified which fibers are in each position in the bundle to be tested. Jim will show me tomorrow how to use the alignment collar for testing. I continued polishing the sci-fi bundle after identifying the fibers.

2/19: Using the Carson camera, I identified which fibers are in each position in the bundle to be tested. Jim will show me tomorrow how to use the alignment jig for testing. I continued polishing the sci-fi bundle after identifying the fibers.

 

2/20: Today I tried aligning the fibers for testing as Jim explained. I have not succeeded with that yet. I also continued polishing the same bundle of sci-fis.