581
edits
Changes
Jump to navigation
Jump to search
Line 63:
Line 63: − + − − 1) Bleed all lines prior to this process. − − 2) Turn on HV supply (turn key to on position) and allow the thyratron to warm up for at least ten minutes. − − 3) Evacuate the laser cavity until the fine gauge reads in the red (zero) by turning on the vacuum pump switch located on the laser head − − 4) Fill the system with 150mbar fluorine and 1850 He making the total pressure 2000mbar. − − 5) Set the Rep. Rate to 10Hz and turn on the HV supply (push button in) − − 6) Turn laser on (push button in) and set High Voltage to 20kV. − − 7) Laser will begin to pulse a red light, allow the laser to fire until the red light's intensity is reduced to about half. For the first few runs it may be necessary to re-fill a few times. The light should last AT LEAST 10 minutes. − − [[User:Bpratt18|Bpratt18]] 17:33, 28 June 2010 (UTC)
Diamond Radiator Thinning Using an Excimer Laser (view source)
Revision as of 02:39, 13 December 2016
, 02:39, 13 December 2016→Passivation for ArF
==Ablation Software==
==Ablation Software==
==Passivation for ArF==
==Initial Results of Diamond Radiators==