179
edits
Changes
Jump to navigation
Jump to search
Line 3:
Line 3: − + − + + + + + + + + + + − + + + + + +
Temperature Control Program (view source)
Revision as of 19:50, 2 December 2015
, 19:50, 2 December 2015no edit summary
The front panel displays a waveform chart, which will display each temperature measurement, digital temperature and time displays, and various controls to set parameters.
The front panel displays a waveform chart, which will display each temperature measurement, digital temperature and time displays, and various controls to set parameters.
=Instructions for a Heating Run=
==Instructions for a Heating Run==
In order to perform a heating run there are
In order to perform a heating run there are a number of parameters, which can be found of the front panel that must be set properly. The conditions for a normal run are listed below:
Samples/Channel: 1 is sufficient here, increase for more data points.<br/>
Rate: 1 is sufficient here, increase for more data points.<br/>
Sample Mode: FiniteSamples<br/>
Save your file?: Pressed if you want to save the run, unpressed if you don't.<br/>
STOP: Must be unpressed at program start.<br/>
Control Manually: Automatic<br/>
Target Temperature: 175<br/>
Timed Heater Turn off: any desired time. (in seconds)<br/>
Start Timer: On to start timer when the program starts, off otherwise.<br/>
=Program logic=
Once
Note that the program will shut the hotplate off for the rest of the run if the highest temperature passes 190 degrees Fahrenheit
==Program logic==