1,870
edits
Changes
Jump to navigation
Jump to search
mLine 61:
Line 61: − + − + − +
Tagger microscope prototype construction (view source)
Revision as of 16:50, 15 January 2008
, 16:50, 15 January 2008→Gluing
*** Kim wipes
*** Kim wipes
*** Digital scale
*** Digital scale
*** Acetone and Isopropanol
*** Acetone and isopropanol
*** A container to mix the epoxy, and a waist container
*** A container to mix the epoxy, and a waste container
*** The resin and catalyst (or hardener) of the epoxy
*** The resin and catalyst (or hardener) of the epoxy
*** A pipette with tip and dispensing pump
*** A pipette with tip and dispensing pump
*** Tongue depressors
*** Tongue depressors
** Once you have collected all the necessary equipment you can begin setting up for gluing. First and foremost, PUT ON GLOVES. Now, take out several kim wipes and place them under the digital scale, the waist container, the resin and catalyst, and on anything that could have unwanted chemicals spilled on. Set 3 or 4 tongue depressors, and 3 or 4 pipettes, off to the side of your workstation so that they are not in the way but easily accessible. Pour some Acetone or Isopropanol in your waist container for quick cleaning. Inspect all glassware make sure that they are completely clean. If you find glassware that is not clean, clean it using Acetone and then wait at least 10 minutes before using the glassware. Now that you are all set up you can begin gluing.
** Once you have collected all the necessary equipment you can begin setting up for gluing. First and foremost, PUT ON GLOVES. Now, take out several kim wipes and place them under the digital scale, the waste container, the resin and catalyst, and on anything that could have unwanted chemicals spilled on. Set 3 or 4 tongue depressors, and 3 or 4 pipettes, off to the side of your workstation so that they are not in the way but easily accessible. Pour some Acetone or Isopropanol in your waist container for quick cleaning. Inspect all glassware make sure that they are completely clean. If you find glassware that is not clean, clean it using Acetone and then wait at least 10 minutes before using the glassware. Now that you are all set up you can begin gluing.
Here is a picture of all the new equipment that is required for the new application process.
Here is a picture of all the new equipment that is required for the new application process.