Difference between revisions of "BW October 2018"

From UConn PAN
Jump to navigation Jump to search
(Created page with "10/1: The popsicle sticks are about 9.5" long. I want a bundle of scraps probably a little longer, maybe 11". If they are too long, I can cut them shorter.")
 
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
 
10/1: The popsicle sticks are about 9.5" long. I want a bundle of scraps probably a little longer, maybe 11". If they are too long, I can cut them shorter.
 
10/1: The popsicle sticks are about 9.5" long. I want a bundle of scraps probably a little longer, maybe 11". If they are too long, I can cut them shorter.
 +
 +
10/9: Tomorrow (10/10) I have to check the fiber configuration with the light.
 +
 +
10/31: Jim said we should use feeler gauges to misalign fibers beyond the end of the popsicle stick. We can have the feeler gauges between the popsicle stick and a straight edge. We can try small 3D-printed pieces that fit between the fiber ends and where they would normally contact the alignment jig.
 +
 +
We may try both misaligning the blocks along with the fibers and aligning the blocks normally while the fibers are correctly aligned.

Latest revision as of 16:47, 31 October 2018

10/1: The popsicle sticks are about 9.5" long. I want a bundle of scraps probably a little longer, maybe 11". If they are too long, I can cut them shorter.

10/9: Tomorrow (10/10) I have to check the fiber configuration with the light.

10/31: Jim said we should use feeler gauges to misalign fibers beyond the end of the popsicle stick. We can have the feeler gauges between the popsicle stick and a straight edge. We can try small 3D-printed pieces that fit between the fiber ends and where they would normally contact the alignment jig.

We may try both misaligning the blocks along with the fibers and aligning the blocks normally while the fibers are correctly aligned.