Changes

#* one readout controller called TROC5

#* one readout controller called TROC5

#* one event builder called EB5

#* one event builder called EB5

#* one event recorder called ER5

#* one event recorder called ER1

# we are still configured to write output data to /home/halld/data which is mounted on /nfs/direct/annex2/TAGM-tests on the cluster

# we are still configured to write output data to /home/halld/data which is mounted on /nfs/direct/annex2/TAGM-tests on the cluster

# Clear the desktop of unwanted windows, and start the CODA runtime with the command "./start_daq.sh" and watch all of the pretty colored windows popping up on the desktop. Check for errors and warnings in each one as it starts.

# Clear the desktop of unwanted windows, and start the CODA runtime with the command "./start_daq.sh" and watch all of the pretty colored windows popping up on the desktop. Check for errors and warnings in each one as it starts.

# Go to the run control gui window and select "Connect" under the "Platform" menu. The Configure button should light up.

# Go to the run control gui window and select "Connect" under the "Platform" menu. The Configure button should light up.

# Click the "Configure" button that appears below the "Platform" menu (farthest to the left). After a moment, the event builder, read-out controller, and event recorder should appear in the table in the center of the gui, as EB1, TROC5, and ER1. You should see messages at the bottom indicating that the configure started and has succeeded.

# Click the "Configure" button that appears below the "Platform" menu (farthest to the left). After a moment, the event builder, read-out controller, and event recorder should appear in the table in the center of the gui, as EB5, TROC5, and ER1. You should see messages at the bottom indicating that the configure started and has succeeded.

# Click the "Download" button immediately to the right of the "Configure" button. By now, the run parameters Expid, session, and configuration should be displayed.

# Click the "Download" button immediately to the right of the "Configure" button. By now, the run parameters Expid, session, and configuration should be displayed.

# Click the "Prestart" button immediately to the right of the "Download" button.

# Click the "Prestart" button immediately to the right of the "Download" button.

# Click "Start" to begin the run. Take care to note any warnings or errors, shown in the bottom message display.

# Click "Start" to begin the run. Take care to note any warnings or errors, shown in the bottom message display.