1,870
edits
Changes
Jump to navigation
Jump to search
mLine 32:
Line 32: − +
Hot Water Fiber Bending Procedure (view source)
Revision as of 16:51, 29 January 2016
, 16:51, 29 January 2016Jonesrt moved page Fiber Bending Procedure to Hot Water Fiber Bending Procedure: make it clear which generation of procedures is being deprecated
The entire bending unit consists of a long unistrut support, the bending plate with threaded metal rods, and two chimney plates. These plates are aligned and clamped together with 4 C-clamps. Do not attach both chimney plates at this stage in the procedure. You must place 15 of the fibers into Chimney Plate 2 before securing Chimney Plate 1 and completing the bundle.
The entire bending unit consists of a long unistrut support, the bending plate with threaded metal rods, and two chimney plates. These plates are aligned and clamped together with 4 C-clamps. Do not attach both chimney plates at this stage in the procedure. You must place 15 of the fibers into Chimney Plate 2 before securing Chimney Plate 1 and completing the bundle.
[[File:LH_BendingUnit.png|thumb|upright|left|A simplified graphic outlining how the plates should be layered when securing the fibers into the plates. The unistrut (long gray bar) should be underneath the bending plate (blue plate with green and yellow rods, and pink collars) and between the two chimney plates (blue plates with yellow chimneys).]]
[[File:LH_BendingUnit.png|thumb|upright|center|A simplified graphic outlining how the plates should be layered when securing the fibers into the plates.]]
{|style="margin: 0 auto;"
{|style="margin: 0 auto;"