Line 10:
Line 10:
* Make sure the Dremel cutting tool is unplugged then visually inspect:
* Make sure the Dremel cutting tool is unplugged then visually inspect:
** Ensure cutting wheel is secure and not cracked
** Ensure cutting wheel is secure and not cracked
+
** Verify electrical cord is in good working order.
+
** Make sure the power switch is in the off position.
+
* Plug in the Dremel tool.
+
* Set the cutting speed to 7.
+
*Check that the ventilation hose is secure and start the ventilation system.
+
*Flip up the opening to the spool storage box to expose the two slots with the protruding optical fibers.
+
*Select a fiber spool to cut from and remove the clip holding the corresponding fiber in place.
+
** Ensure the fiber is held securely prior to release of the clip
+
** If the fiber falls into the storage box:
+
*** Remove the side panel on the spool storage box using a razor knife to cut the tape.