1,004
edits
Changes
Jump to navigation
Jump to search
mLine 299:
Line 299: − − +
Programming the Ethernet controller (view source)
Revision as of 18:01, 14 November 2007
, 18:01, 14 November 2007→(010) Idle
* ''TxRx_R/W'': read/write flag for transceiver
* ''TxRx_R/W'': read/write flag for transceiver
* ''TxRx_Aout'': register address bus for transceiver
* ''TxRx_Aout'': register address bus for transceiver
blocks
blocks
* '''Register INT0RD (0x76)''' request via <tt>reqFromAddr</tt> pulsed by the ''LoopEn'' signal from Looper (below).
* '''Request INT0RD''' (0x76) register via <tt>reqFromAddr</tt> pulsed by the ''LoopEn'' signal from Looper (below).
* '''Looper'''
* '''Looper'''
** Switch to determine if this state should loop on itself or continue to the next state.
** Switch to determine if this state should loop on itself or continue to the next state.