Difference between revisions of "Design and prototyping of SiPM electronics"
Jump to navigation
Jump to search
m |
m |
||
| Line 24: | Line 24: | ||
== To-do list == | == To-do list == | ||
| + | * Upload [[Programming the ADC|ADC module]] block diagrams | ||
* Combine [[Programming the ADC|ADC]] & [[Programming the temperature sensor|temperature sensor]] into single "SPI" module | * Combine [[Programming the ADC|ADC]] & [[Programming the temperature sensor|temperature sensor]] into single "SPI" module | ||
* [[Reset and Initialization|Reset module]] | * [[Reset and Initialization|Reset module]] | ||
Revision as of 19:45, 17 July 2007
This page is a work in progress. More information will be added as the project progresses.
Links
Analog amplifier
- SiPM Amplifier - analog amplifier circuit supplied by Photonique for use with the SiPMs.
- MATLAB amplifier in detail - more information regarding the implementation of the MATLAB-based simulation of the amplifier circuit.
Digital control
- SiPM digital control board - digital PCB for controlling the SiPMs.
- Programming the FPGA - central page for programming the FPGA.
- Programming the DAC - discussion of the design for the DAC.
- Programming the temperature sensor - discussion of the design for the temperature sensor.
- Programming the ADC - discussion of the design for the ADC.
- Programming the Ethernet controller - discussion of the design for the Ethernet controller.
- Ethernet packets - a detail of the packets we intend to use on our network.
- Reset and Initialization - discussion of the design for the reset and initialization core.
- VHDL tutorial - a brief guide to VHDL design with a design example; the introduction and core of the tutorial.
- VHDL: Where to start - section one of the tutorial, focusing on preparing your design for coding.
- VHDL: Enter the code monkey - section two of the tutorial, focusing on outlining the framework of your code.
- VHDL: The real code - section three of the tutorial, focusing on coding the body of your design.
- VHDL: Xilinx ISE - section four of the tutorial, focusing on using the development environment.
To-do list
- Upload ADC module block diagrams
- Combine ADC & temperature sensor into single "SPI" module
- Reset module
- Execute on startup
- Execute on command
- Integrate with/combine into existing modules
- Ethernet controller module
- Integrate all modules
- Determine size of FPGA
- Design or purchase connector to bus board
- Purchase all components (including EEPROM, RJ-45 female jack, etc)
- Obtain footprints of all chips, connectors, jacks, etc
- PCB layout
- Prototype PCB
- Design bus board
- Design analog board