C This is the control file for the GEANT simulation.  Parameters defined
C in this file control the kind and extent of simulation that is performed.
C The full list of options is given in section BASE-40 of the GEANT manual.
C
C In addition, some new cards have been defined to set up the input source
C for the simulation.  Three kinds of simulation runs are available, selected
C by which of the following three "cards" are present below.
C    1. Input from Monte Carlo generator (card INFILE)
C    2. Built-in coherent bremsstrahlung source (card BEAM)
C    3. Built-in single-track event generator (card KINE)
C The order of the list is significant, that is if INFILE is present then the
C BEAM and KINE cards are ignored, otherwise if BEAM is present then KINE is
C ignored.  For example, the 3-card sequence:
C     INFILE 'phi-1680.hddm'
C     SKIP 25
C     TRIG 100
C instructs HDGeant to open ./phi-1680.hddm, skip the first 25 events and then
C process the following 100 input events and stop.  If the end of the file is
C reached before the event count specified in card TRIG is exhausted then the
C processing will stop at the end of file.

c TRIG 1000
c INFILE 'rhop.hddm'
BEAM 12.0 9.0 
RUNG 9999

C The following card enables single-track generation (for testing)
C    particle  energy  theta  phi  vertex(x y z)
KINE    3        1.0     80.  45.    0. 0. 65.

RNDM 172

CUTS 1e-4 1e-4

SWIT 0 0 0 0 0 0 0 0 0 0

C The following card enables the GelHad package (from BaBar)
C   on/off  ecut   scale   mode   thresh
GELH  1     0.2     1.0     4     0.160

CKOV 1
LABS 1

END